Job Safety Brief
Sat, October 10, 2026
Foreman / Crew Lead
John Hart
Job site
Jefferson county
Type of work
Storm restoration
JSB index #
1
Job details
Job activity
Storm restoration
Weather
Rainey
Crew on site
Ryder, Matt, Alex,Davis, John
Submitted by
ryderhart807@gmail.com
Emergency information
Notification person
Ryder
Backup
Matt
Radios & cell working
Yes
Nearest hospital
UAB medical west hospital
Hospital address
35022, 1201 11th ave S, Birmingham, Al, 35205
Muster point
Forman truck
Injury hotline
CORE 844-953-8234 (24/7) · 911 for emergencies
Job steps, hazards & safe actions
| # | Job step | Potential hazards | Safe actions |
|---|---|---|---|
| 1 | Drive to job | Wet roads, other traffic | Use causation when driving , check surrounds before merging lanes and watch other drivers |
| 2 | Put out signs and cones | Getting hit by car | Look before entering roadway |
| 3 | Hanging grounds | Generator back feed | Test wire before hanging ground |
| 4 | Remove tree off of line | Falling trees, wire breaking or poles breaking | Secure wire before cutting tree, stay clear of tree falling |
| 5 | Remove grounds and re energize wire | Energize line | Make sure all men and equipment are in the clear, check rest of line before re-energizing |
| 6 | Drive back | Traffic and wet roads | Take precaution while driving |
Energy isolation
Clearance / control held by
John hart
FR clothing (min.)
CAT 2
Hazard controls briefed
Energized Electrical
- Voltage identified / treat as energized until proven otherwise
- Minimum Approach Distance established and briefed
- Cover-up / rubber goods installed (line hose, blankets, hoods)
- Rubber gloves and sleeves inspected, air-tested, and in test date
- Protective grounds / equipotential grounding installed
- Switching, clearance, or hold card obtained and isolation verified
- Test before touch
- Backfeed controlled (customer generators / parallel sources)
- Step and touch potential controlled
Energy Isolation & Control
- Clearance / control in place
- Protective grounds installed
Aerial Lift / Digger Derrick / Crane
- Equipment inspected
- Outriggers set and cribbing used
- Spotter used
- No personnel under suspended load
Climbing & Fall Protection
- Harness and lanyard / SRL inspected
- Anchorage point identified
- Rescue-at-height plan
Ladders
- Inspect before use
- Use 3-point contact
- Secure ladder at top or bottom
Work Zone & Traffic Control
- Signs, cones, and flaggers
- High-visibility clothing
Storm & Environmental
- Generator backfeed controlled
- Chainsaw / vegetation
Human Performance
- Pre-task planning
- Fit for duty
- Stop and think
- Peer check
- Avoid rushing
- Verify critical steps
- Ask questions
- Job briefing held with all crew (OSHA 1910.269)
Required PPE
Hard hat / Class ESafety glassesFR clothingTested rubber gloves & sleeves (by class)Leather protectorsWork glovesProper footwear (EH-rated)100% fall protection (harness / lanyard / SRL)Temporary protective groundsSwitch stick / hot stickInsulated line toolsHi-vis traffic vestTraffic cones & signs
Crew (5)
- John Hart
- Ryder Hart
- Davis Burcham
- Matthew Smith
- Thomas Johnson
4 team member signatures captured · Job briefing acknowledged (OSHA 1910.269)